1.Introduction
SterlingShield S4 is specifically designed for workpieces where water-based protective agents are unsuitable. It can be used to protect copper plating as well as thin silver or thin tin plating over copper. On red copper, it achieves up to 120 hours in neutral salt spray testing. On silver plating, it effectively increases tarnish resistance, provides lubricity, reduces the coefficient of friction, and is non-irritating. Its protective performance enhances the corrosion resistance of non-ferrous metals against moisture, salt spray, marine climate corrosion, mold/fungi, and industrial atmospheres, without adversely affecting the electrical conductivity or solderability of the products. SterlingShield S4 is also widely used on reel-to-reel production lines to provide additional protection.
2.Technical & Physical Properties
1. Appearance/State: Colorless, transparent with a slight milky-white tint
2. Film thickness: Approx. 100–500 nm
3. Coverage rate: Approx. 10–30 m²/kg
4. Shelf life: Two years
3.Process Flow
1.Electroplating
2.Thorough cleaning (free of corrosion, oil, and moisture)
3.Immersion in protective agent (at 45–50 °C for approx. 30 seconds; for larger batches or oversized workpieces, preheat the workpieces to 45–50 °C before immersion)
4.Oven drying
5.For workpieces or equipment unsuitable for dip coating: brush-apply using a clean bristle brush and blow-dry with hot air (heat gun/hair dryer) for 3–5 minutes
6.Inspection
7.Packaging
4.Precautions
1.Never use an open flame to heat the solution; heat it strictly in a water bath to prevent fire hazards.
2.Promptly cap and seal the container after use and store it in a cool place to prevent solvent evaporation. During operation, never allow water to mix into the protective agent solution.
3.Because the solvent will evaporate to some extent during use, replenish with an appropriate amount of thinner/diluent as needed.
5.Disclaimer
All proposals or suggestions regarding our company's products in this manual are based on experiments and data that our company trusts. Due to the inability to control the actual operations of other practitioners, our company cannot guarantee or be responsible for any adverse consequences.